Teste

Sunding Bicycle Computer
SD-536B
-

hinder the movement of the front wheel.

(14Functions)

Computer
Attach the computer to the mounting shoe by sliding the unit until it snaps firmly into its position. To remove it, press the button on it in the opposite direction. To check for proper speed function and sensor alignment, spin the front wheel with computer in speed mode. Adjust the position of sensor and magnet when there is no or weak reaction.

Reset of Mileage Parameter
Press and hold both RIGHT and LEFT button simultaneously for 3 seconds to clear the circumference and (km/m) setting. The user need to reset the tyre circumference and (km/m), the original ODO value and CLOCK will remain unaffected.

SCAN
In Scan mode , DST, MXS, AVS and TM mode are indicated in turn every 4 seconds. Press the RIGHT button to enter CLOCK Mode.

FUNCTIONS
SPD CURRENT SPEED ODO ODOMETER （0.001～99999km/m) DST TRIP DISTANCE MXS MAXIMUM SPEED AVS AVERAGE SPEED TM ELAPSED TIME CLK CLOCK （12H/24H） SCAN “+” “－” COMPARATOR SETTING SPEED SCALE（km/h,m/h） SETTING TYRE CIRCUMFERENCE : (0mm ～ 9999mm) SETTING THE LAST VALUE OF ODOMETER/ODO FREEZE FRAME MEMORY AUTO ON/OFF

Sleep Mode
If no signal has been inputted for 300 seconds, computer will enter into Sleep Mode, CLK value remains. It will turn back to the former mode with all the data collected then when any signal is inputted or any button is pressed.

Speedometer
Speed is shown all the time on the screen, its maximum reading is 99.9km/h (m/h), and it’s accurate to +/0.1km/h (m/h).

Wheel Size Input
‘2060’ appears on the screen when the battery has been installed, with one figure flashing, choose the correct wheel circumference from the table below. Press RIGHT button to advance digits as needed and LEFT button to confirm and advance. (The circumference ranges 0mm～9999mm),press LEFT button to enter KM/M mode. CIRC CIRC TIRE SIZE TIRE SIZE 700c x 38mm 700c x 35mm 700c x 32mm 700c x 30mm 700c x 28mm 700c x 25mm