C a n o py T M Subscriber Module
USER MANUA L
SM02-UG-en Issue 2 May 2003
© 2003 Motorola, Inc. All rights reserved. Printed in the U.S.A
Important Note on Modifications
Intentional or unintentional changes or modifications to the equipment must not be made unless under the express consent of the party responsible for compliance. Any such modifications could void the user’sauthority to operate the equipment and will void the manufacturer’s warranty.
U.S. Federal Communication Commision (FCC) and Industry Canada (IC) Notification
This device complies with part 15 of the U. S. FCC Rules and Regulations and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This devicemust accept any interference received, including interference that may cause undesired operation. In Canada, users should be cautioned to take note that high power radars are allocated as primary users (meaning they have priority) of 5250 – 5350 MHz and 5650 – 5850 MHz and these radars could cause interference and/or damage to license-exempt local area networks (LELAN). This equipment has beentested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the U.S. FCC Rules and with RSS-210 of Industry Canada. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with theseinstructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to correct the interference by one or more of the following measures: Increase the separation between the affected equipment and the unit; Connect the affected equipmentto a power outlet on a different circuit from that which the receiver is connected to; Consult the dealer and/or experienced radio/TV technician for help. FCC ID: ABZ89FC3789 FCC ID: ABZ89FC4816 FCC ID: ABZ89FC5804 IC: 109W-5200 IC: 109W-5700
The term “IC:” before the radio certification number only signifies that Industry Canada technical specifications were met.
Notification of Intended Purpose of Product Uses This product is a two-way radio transceiver suitable for use in Broadband RLAN systems. It uses operating frequencies which are not harmonized through the EC. All licenses must be obtained before using the product in any EC country.
Declaration of conformity:
Motorola declares the GHz radio types listed below comply with the essentialrequirements and other relevant provisions of Directive1999/5/EC. Relevant Specification EN 301 893 or similar - radio spectrum EN301489-17 - EMC EN60950 - safety
SM User Manual Issue 2
Page 2 of 34
Product Details for Products Tested for Compliance with Relevant EC Directives (At this time, only the 5.7 GHz product has been tested for compliance with relevant EC directives.) ModulationChannel Effective Operating Maximum Type Spacing Frequency Range Transmitter Isotropic Power Radiated Power (EIRP) Access Point 5.725 to 5.825 GHz 200mW RMS 1 Watt EIRP High Index 25 MHz BFSK 20 MHz Subscriber Module Subscriber Module with Reflector Backhaul Backhaul with Reflector 5.725 to 5.825 GHz 5.725 to 5.825 GHz 200mW RMS 200mW RMS 1 Watt EIRP 63 Watts EIRP High Index BFSK High Index BFSK HighIndex BFSK High Index BFSK 25 MHz 20 MHz 25 MHz 20 MHz 25 Mhz 20 MHz 25 MHz 20 MHz
5.725 to 5.825 GHz 5.725 to 5.825 GHz
200mW RMS 200mW RMS
1 Watt EIRP 63 Watts EIRP
The Canopy Subscriber Module (SM) must be installed to provide a separation distance of at least 20 cm (7.9 in) from all persons, when adding the Canopy reflector dish (in the 5.7 GHz band), the...
Ler documento completo
Por favor, assinar para o acesso.